Instructions for use

en
42
 Curtains, fabric
 Upholstery, cushions
 Cut pile carpets, rugs and run-
ners
 Energy-saving vacuuming. This
setting is also very quiet
 Loop pile carpet and rugs
 Hard flooring and heavily soiled
carpets and rugs
When using the adjustable floorhead,
if the suction seems too high, reduce
the suction until the floorhead is
easier to manoeuvre.
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following suction power se-
lectors:
– Foot controls
– Radio-control handle
Foot controls (dia. 24)
The first time the vacuum cleaner is
switched on, the highest setting will be
selected automatically.
After that the vacuum cleaner will
switch on at the setting which was used
previously.
 Press the + foot control to select a
higher setting.
 Press the - foot control to select a
lower setting.
Radio-control handle (dia. 25)
When the vacuum cleaner is switched
on with the On/Off foot control , the
Standby indicator  on the vacuum
cleaner will light up yellow.
 Press the Standby button  on the
handle.
The Standby indicator  on the va-
cuum cleaner will go out.
The first time the vacuum cleaner is
switched on, the highest setting will be
selected automatically.
After that the vacuum cleaner will
switch on at the setting which was used
previously.
 Press the + button to select a higher
suction power level.
 Press the - button to select a lower
suction power level.
Opening the air inlet valve (dia. 26)
(not on models with LEDs or radio con-
trols on the handle, or Eco Comfort
handles)
It is easy to reduce the suction power
for a short time, e.g. to prevent rugs or
other objects being sucked into the va-
cuum cleaner.
 Open the air inlet valve on the handle
far enough to reduce the suction
power.
The floorhead will be easier to man-
oeuvre.