Operating instructions/Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Guide to the appliance
- Unpacking and installing
- Operation
- Before first use
- The bean system
- Filling the water tank
- Switching on and off
- Dispenser adjustment
- Cup heating
- Making coffee with and without milk
- Making coffee with milk
- Tea
- Dispensing hot water
- Parameters
- Portion size
- Resetting drinks
- Profiles
- Profiles: creating and processing drinks
- Profiles: making drinks
- Expert mode
- Settings
- Networking
- Cleaning and care
- Overview of cleaning intervals
- Clean by hand or in dishwasher
- Unsuitable cleaning agents
- Cleaning the drip tray and grounds container
- Cleaning the drip tray cover
- Cleaning the water container
- Removing and cleaning the water container filter
- Cleaning the main dispenser with integrated cappuccinatore
- Removing and cleaning the cup sensor
- Cleaning the milk siphon
- Cleaning the milk flask
- Cleaning the milk pipe manually or using the maintenance program
- Cleaning the bean system
- Cleaning the ground coffee drawer
- Vacuuming out the ground coffee chute
- Cleaning the casing
- Maintenance programs
- Rinsing the appliance
- Rinsing the milk pipe
- Cleaning the milk pipework
- Degreasing the brew unit and cleaning the interior
- Descaling the appliance
- Automatic descaling
- Frequently Asked Questions
- Customer Service
- Transport
- Accessories
- Saving energy
- Electrical connection
- Appliance dimensions
- Technical data
- FCC Declaration of Conformity
Cleaning and care
74
Clean the surfaces of the main
dispenser with a damp cloth.
If the milk pipe connecting pieces are
blocked, clean them under running
water with the brush supplied:
Insert the brush into the pipe
connecting piece. Move it back and
forth until all milk residue has been
removed.
If you have released the connecting
piece from the milk pipe: when
reassembling, ensure that the smaller,
thinner end of the connecting piece is
pushed into the hose.
Reassembling the main dispenser
The dispensing unit is easier to
reassemble if the individual parts are
dampened with water beforehand.
Reassemble the dispensing unit.
Push the dispensing spouts firmly
back onto the dispensing unit.
Make sure that all parts are tightly
connected to one another.
Push the dispensing unit back into
the main dispenser and replace the
stainless steel cover.
TapOK.
Tip: If the coffee machine is switched
off, the main dispenser components
can be removed and cleaned at any
time.
Removing and cleaning the
cup sensor
The cup sensor is located under the
main dispenser.
Clean the cup sensor daily by hand with
warm water and a little liquid dish soap.
Press the two catches together (see
arrows).