Operating instructions/Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Guide to the appliance
- Unpacking and installing
- Operation
- Before first use
- The bean system
- Filling the water tank
- Switching on and off
- Dispenser adjustment
- Cup heating
- Making coffee with and without milk
- Making coffee with milk
- Tea
- Dispensing hot water
- Parameters
- Portion size
- Resetting drinks
- Profiles
- Profiles: creating and processing drinks
- Profiles: making drinks
- Expert mode
- Settings
- Networking
- Cleaning and care
- Overview of cleaning intervals
- Clean by hand or in dishwasher
- Unsuitable cleaning agents
- Cleaning the drip tray and grounds container
- Cleaning the drip tray cover
- Cleaning the water container
- Removing and cleaning the water container filter
- Cleaning the main dispenser with integrated cappuccinatore
- Removing and cleaning the cup sensor
- Cleaning the milk siphon
- Cleaning the milk flask
- Cleaning the milk pipe manually or using the maintenance program
- Cleaning the bean system
- Cleaning the ground coffee drawer
- Vacuuming out the ground coffee chute
- Cleaning the casing
- Maintenance programs
- Rinsing the appliance
- Rinsing the milk pipe
- Cleaning the milk pipework
- Degreasing the brew unit and cleaning the interior
- Descaling the appliance
- Automatic descaling
- Frequently Asked Questions
- Customer Service
- Transport
- Accessories
- Saving energy
- Electrical connection
- Appliance dimensions
- Technical data
- FCC Declaration of Conformity
Cleaning and care
73
Cleaning the main dispenser
with integrated cappuccinatore
With the exception of the stainless steel
cover, all parts of the main dispenser
should be cleaned in the dishwasher at
least once a week. This will remove
coffee deposits and milk residues
effectively.
Clean the main dispenser stainless steel
cover by hand only using warm water
and a little liquid dish soap.
The Drinks menu is displayed.
If the main dispenser is in the
uppermost position, it cannot be
dismantled. The main dispenser must
be moved into the maintenance position
to do this.
Tap for 3 seconds.
The main dispenser will move into the
maintenance position.
Pull the stainless steel cover off.
Remove the dispensing unit towards
the front.
Twist off the upper section with the
holder for the milk pipe. Pull the
component off. Then pull the Y-
shaped piece off. Remove the
dispensing spouts.
Clean all parts thoroughly.