Operating Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the appliance
- Controls and display
- Accessories
- Before using for the first time
- Operation
- Filling the water tank
- Filling the coffee bean container
- Turning the machine On and Off
- Cup heating
- Adjusting the coffee dispensers to the cup height
- Preparing beverages
- Making coffee with milk
- Grinder setting
- Amount of coffee, brew temperature and pre-brewing
- Portion size
- User profiles
- Settings
- Cleaning and care
- Overview
- Clean by hand or in dishwasher
- Drip tray and grounds container
- Drip tray cover
- Water container
- Stainless steel water intake valve filter
- Main dispenser with cappuccinatore
- Stainless steel milk flask
- Milk pipework
- Bean container and ground coffee chute
- Housing
- Care programs
- Rinsing the coffee system
- Rinsing the milk pipework
- Cleaning the milk pipework with the maintenance program
- Degreasing the brew unit and cleaning inside
- Descaling the machine
- Frequently Asked Questions
- Transport
- Technical Service
- Saving energy
- Electrical connection
- Installation
- Appliance dimensions
- Technical data
Frequently Asked Questions
76
Unsatisfactory results
Problem Possible cause and solution
The coffee is not hot
enough.
The cup has not been pre-heated.
The smaller the cup and the thicker its walls, the more
important it is to pre-heat it.
Pre-heat the cups, e.g. using the cup heating (ac-
cording to model).
The brewing temperature is set too low.
Set a higher brewing temperature (see "Brewing
temperature").
The brew unit filters are blocked.
Remove and clean the brew unit by hand (see "Re-
moving the brew unit and cleaning it by hand").
Degrease the brew unit (see "Brew unit").
Heating-up is taking
longer. The amount of
water is no longer cor-
rect and the coffee ma-
chine is not performing
properly. Coffee flows
into the cup very slowly.
The coffee machine needs to be descaled.
Descale the coffee machine.
The amount of coffee or
espresso dispensed has
changed.
This is not a fault.
You probably changed the drink size by pressing the
sensor longer. Touching the drink buttons for longer
starts quantity programming for the respective drink
("Portion size"). If you do not save a portion size, the
maximum possible amount is saved for this drink.
The consistency of the
milk froth is unsatisfac-
tory.
The milk temperature is too high. Good milk froth can
be achieved when cold milk (< 50°F/10°C) is used.
Check the temperature of the milk in the milk flask.
The milk pipework is blocked.
Clean the central spout with integrated cappucci-
natore and the milk pipework with the cleaning
brush supplied.