Specs
Pre-finished
24” MasterCool
Please note the following:
• This specication sheet is for a single built-in unit.
• When combining multiple MasterCool units side-by-side, please refer to the Merging Kit specication sheet.
*If design calls for a partition less than 6
5
/16” (160 mm) the left unit’s cutout will require an additional
1
/8” (3 mm) to the width to allow installation of
the Heating Mat/Merge Kit.
SPECIFICATIONS
Overall Unit Dimensions 23
3
/4” (603 mm) W x 83
3
/4”- 85
3
/16” (2127 - 2164 mm) H x 24” (610 mm) D [Excludes Fascia Dimension]
Overall Fascia Dimensions 24
1
/2” (622 mm) W x 84”- 85
11
/16” (2134 - 2175 mm) H x 1
1
/2” (32 mm) D
Niche
Minimum Cabinet Niche Opening 24” (610 mm) W* x 84” - 85
3
/16” (2134 - 2164 mm) H x 24” (610 mm D
Electrical
K 2602 SF KWT 26x2 SF(S) F 2672 SF
Electrical Requirements
110V / 120V, 60Hz, 15 Amps
In the case of side-by-side installations, a separate outlet must be used for each appliance.
Power Cord NEMA 5-15 plug, 5 ft (1.52 m)
Plumbing K 2602 SF KWT 26x2 SF(S) F 2672 SF
Water Supply Requirements -
Connect to a cold water supply only. Do not connect to a
low-mineral or a reverse osmosis system. Must be connected
to a shut-off valve. The water shut-off valve must be accessible
after installation. The water pressure must be between 29 psi
(2 bar) and 116 psi (8 bar). If the pressure is higher than 120 psi
(8.3 bar), a pressure reducing valve must be installed.
Water Connection Line
-
Standard 1/4” O.D flexible water line. The maximum outer
diameter of the water pipe (without fittings): 3/8” (10 mm).
Water line is not included.
Shipping
K 2602 SF KWT 26x2 SF(S) F 2672 SF
Shipping Weight 398 lbs (180.5 kg) 416 lbs (189 kg) 435 lbs (197 kg)
Shipping Dimensions 26
7
/8” (682 mm) W x 84
1
/4” (1,240 mm) H x 29
7
/8” (759 mm) D
K 2602 SF (Right Hinged)
Material# 11502570
F 2672 SF (Left Hinged)
Material# 11503570
KWT 2602 SF (Right Hinged)
Material# 11503620
KWT 2612 SF (Left Hinged)
Material# 11503640
Page 2 of 6
KWT 2662 SFS (Right Hinged)
Material# 11503670