Specs

ManualsBrandsMiele ManualsCombi-Sets15" CS 1221 I Induction Cooktop Combiset™

Product and Cut-out Dimensions Page 1 of 4

CS 1221 I Induction CombiSet

1221

Induction

CombiSet

Location Codes

1 – Spring clips

2 – Appliance front

3 – Installation height

4 – Power supply box with connection cable Length =47 ¼” (1200 mm)

4 Power supply box with connection cable, Length 47 ¼ (1200 mm)

208 V, 60 Hz, 20 A fuse rating

240

V, 60 Hz, 20 A fuse rating

Ensure that the power outlet is accessible after installation

5 – Rating label – Ensure that the electrical supply matches the rating. Adhere rating label sticker supplied with the

appliance into the manual.

Shipping weight 25 lbs (11.3 kg)

Shipping dimensions 23” (584 mm) L x 19” (483 mm) W x 8” (203 mm) H

Notes

Indoor use

The appliance must not be permanently sealed into the countertop when installed. The sealing strip under the edge of

the appliance provides a sufficient seal for the countertop.

All installations must be done in accordance with local codes.

Drawing is not to scale Specification Sheets OJS

02212012

Summary of content (4 pages)

PAGE 1
Product and Cut-out Dimensions Page 1 of 4 CS 1221 I Induction CombiSet Location Codes 1 – Spring clips 2 – Appliance front 3 – Installation height 4 – Power supply box with connection cable cable, Length =47 47 ¼ ¼” (1200 mm) 208 V, 60 Hz, 20 A fuse rating 240 V, 60 Hz, 20 A fuse rating Ensure that the power outlet is accessible after installation 5 – Rating label – Ensure that the electrical supply matches the rating. Adhere rating label sticker supplied with the appliance into the manual.
PAGE 2
Product and Cut-out Dimensions Page 2 of 4 CS 1221 I Induction CombiSet Cut-out Dimensions For two CombiSet Appliances Cut-out Dimensions For three CombiSet Appliances For the installation of two appliances the width of the countertop cut-out D is the sum of A and C. For the installation of three appliances the width of the countertop cut-out D is the sum of A and B and C.
PAGE 3
Product and Cut-out Dimensions Page 3 of 4 CS 1221 I Induction CombiSet The illustration above represents the attachment of spring clips 1 and support bars 2 for 3 appliances An additional support bar is required for each additional appliance. The position for the attachment of an additional support bar depends on the width of appliance B.
PAGE 4
Product and Cut-out Dimensions Page 4 of 4 CS 1221 I Induction CombiSet Safety distances to back wall 1 – Wall frame 2 – Wall covering x = thickness of the wall covering 3 – Countertop p cut-out 4 – Countertop 5 – Minimum safety distance with flammable materials 2" (50 mm) with non-flammable materials 2" (50 mm) minus x If a wall covering is installed, a minimum safety distance must be maintained between the countertop cut-out and the covering, since high temperatures can damage these materials.