User Manual

Making ice cubes
72
Check and pay attention to the follow-
ing before switching the ice-cube maker
on:
- The ice-cube maker must be clean.
- The refrigeration appliance must be
switched on.
- The ice-cube drawer contains an ad-
justable partition. You can adjust the
size of the area in which the ice
cubes will collect depending on the
amount of ice you require.
- The drawer area below the ice-cube
maker must be empty.
- Ice cubes can only be made when
the ice-cube drawer is completely
closed.
 Risk to health due to contami-
nated water.
Bacteria can develop in water which
has been sitting in the water-supply
lines for too long. This poses a risk to
your health.
Throw away the first 3 batches of ice
cubes made after the ice-cube
maker is started up, as the water will
have been used for the initial rinsing
of the water-supply line.
This applies to the initial commis-
sioning as well as when using the
ice-cube maker again after it has
been switched off for an extended
period of time (more than 5days).
When using the appliance for the first
time, it can take up to 24hours for the
first ice cubes to drop out of the ice-
cube maker and collect in the drawer.
After the ice-cube maker has been
turned off and on again, it can take up
to 6hours for this process to be com-
pleted.
Only make normal domestic quantities
of ice cubes with the ice-cube maker.
The ice-cube maker can make up to
approx. 2.6 lb (1.2kg) of ice cubes in
24hours.
The amount of ice cubes made by the
appliance depends on the temperature
in the freezer section. The lower the
temperature, the more ice cubes
are produced.
Switching the ice-cube
maker on and off
 Tap.
 Swipe left or right until is shown in
the middle.
 Tap.
will light up orange when the ice-
cube maker is switched on.
Once the freezer section has cooled
down to its set temperature, the ice-
cube maker will fill with water.