Technical data

Electrical connection
40
WARNING: TO REDUCE THE RISK
OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
All electrical work should be
performed by a q
ualified electrician
in strict accordance with national
regulations (for USA: ANSI-NFPA 70)
and local safety regulations.
Installation, repairs and other work
by unqualified persons could be
dangerous.
Ensure that power to the appliance is
OFF while
installation or repair work
is performed.
Verify that the voltage, load and
circ
uit rating information found on
the data plate (located behind the
baffle filters), match the household
electrical supply before installing the
hood.
Use only with ventilation hood cord-
connection kits that have been
in
vestigat
ed and found acceptable
for use with this model hood.
If there is any question concerning
the electrical connection of this
applianc
e t
o your power supply,
please consult a licensed electrician
or call Miele’s Technical Service
Department.
WARNING: THIS APPLIANCE MUST
BE GROUNDED
The hood comes equipped with a
power cord with a NEMA
5-15 molded
plug for connection to a 120 VAC,
60 Hz, 15 A power outlet.
Grounding Instructions
WARNING - Improper grounding can
resul
t in a risk of electric shock.
This appliance must be grounded. In
the event of an electrical shor
t circuit,
grounding reduces the risk of electric
shock by providing a path of least
resistance. This appliance is equipped
with a cord having a grounding wire
with a grounding plug.
If there is any doubt, have the electrical
system of the house
checked by a
qualified electrician.
Do not use an extension cord. If the
power suppl
y cord is too short, have a
qualified electrician install an outlet
near the appliance.
 The plug must be plugged into an
outl
et that is properly installed and
grounded.
WARNING - Grounding instructions
(Cana
da)
The grounding-type attachment plug
shall be connected to a grounding-
type receptacle installed in
accordance with CSA C22.1-12,
Canadian Electrical Code, Part I.