User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Select programme settings
- 4. Load the washing machine
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Garment care label symbols
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Favourite programmes
- Washing assistant
- Timer
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Replacing the TwinDos cartridge
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Consumption data
- Technical data
- Settings
- Detergents and care products
Problem solving guide
76
Fault message at the end of a programme
Problem Cause and remedy
Intensive flow: Clean
the filter and jet or
remove foreign ob-
jects from the pump
housing.
The pumps are dirty.
Clean the pumps as described in “Problem solving
guide . .“, Opening the door in the event of a
blocked drain outlet and/or power cut”.
Restart the programme after cleaning.
The jet in the top of the door ring is blocked with fluff.
Remove the fluff with your finger. Do not use any
sharp or pointed tools to do this.
Restart the programme after cleaning.
If the fault message appears again, contact Miele.
The washing machine can still be used but with re-
duced functionality.
Align the machine.
Laundry not properly
spun
The Pre-ironing Extra which runs at the end of the pro-
gramme could not be carried out properly.
Check whether the washing machine is aligned
correctly as described in “Installation – Levelling
the machine”.
Check whether the maximum delivery head of 1m
has been exceeded.
If the fault message appears again, contact Miele.
The washing machine can still be used but with re-
duced functionality.
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the OK sensor.