User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Select programme settings
- 4. Load the washing machine
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Garment care label symbols
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Favourite programmes
- Washing assistant
- Timer
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Replacing the TwinDos cartridge
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Consumption data
- Technical data
- Settings
- Detergents and care products
Before using for the first time
21
Switch on the washing ma-
chine
Press the button.
The welcome screen will light up.
The display will guide you through the
6steps of the initial commissioning
process.
1. Set the language
You will be asked to select the language
you require for the display. It is possible
to change the language at any time via
the settings menu.
english (GB)
Language
english (US)
español
français (F)
français (CA)
hrvatski
OK
Scroll to the left or the right until the
language you want appears.
Touch the sensor for the language
you want.
The selected language will be high-
lighted in orange and the display will
change to the menu for setting up
Miele@home.
2. Setting up Miele@home
Skip
Continue
Set up “Miele@home”?
To set up Miele@home now: Touch
the Continuesensor control.
Tip: To postpone setup until later:
Touch the Skipsensor control. The fol-
lowing message will then appear in the
display:
It is possible to set up later in “Settings” /
“Miele@home”.
Confirm with the OKsensor control.
Via WPS Via App
Which connection method do you
want to use?
Select the connection method you
wish to use.
You will then be guided by the display
and the Miele app.