User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Select programme settings
- 4. Load the washing machine
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Garment care label symbols
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Favourite programmes
- Washing assistant
- Timer
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Replacing the TwinDos cartridge
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Consumption data
- Technical data
- Settings
- Detergents and care products
Operating the washing machine
14
Control panel
Start/Stop
a
Sensor
To go back a level in a menu.
b
Touch display
c
Start/Stopsensor control
Touching the Start/Stopsensor control starts the selected programme or can-
cels a programme that has already been started. The programme can be star-
ted as soon as the sensor control is flashing on and off. The sensor control
lights up constantly once the programme has started.
d
Optical interface
This is used by the Service department as a transmission point.
e
Sensor
For switching the washing machine on and off. To save energy, the washing
machine will switch off automatically. This occurs 15minutes after the end of
the programme/anti-crease phase, or after being switched on if no further se-
lection is made.
Touch display and sensor controls
The and Start/Stop sensors and the sensors in the display react to finger tip
contact.
The touch display can be scratched by pointed or sharp objects, e.g. pens.
Only touch the display with your fingers.