User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Garment care label symbols
- Extra options
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Using fabric conditioner or starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Consumption data
- Technical data
- Settings
- Accessing the Settings menu
- Selecting settings
- Changing a setting
- Closing the settings menu
- _
- Buzzer volume
- Keypad tone
- Welcome tone
- Consumption
- Code
- Units
- Brightness
- Disp. switch-off stat.
- Programme info
- Memory
- Long p-wash Cotton
- Soak duration
- Gentle action
- Temp. reduction
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Low water pressure
- Anti-crease
- Miele@home
- _
- SmartGrid
- RemoteUpdate
- Copyrights and licences for the communication module
- Detergents and care products
Problem solving guide
62
Fault message at the end of a programme
Problem Cause and remedy
Check filter + jet
The pumps are soiled.
Clean the pumps as described in “Problem solving
guide – Opening the door in the event of a blocked
drain outlet and/or power failure”.
Restart the programme after cleaning.
The nozzle in the top of the door ring is blocked with
fluff.
Remove the fluff with your finger. Do not use any
sharp or pointed tools to do this.
Restart the programme after cleaning.
If the fault message appears again, contact the Miele
Customer Service Department. The washing machine
can still be used but with reduced functionality.
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the OKsensor control.