User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Garment care label symbols
- Extra options
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Using fabric conditioner or starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Consumption data
- Technical data
- Settings
- Accessing the Settings menu
- Selecting settings
- Changing a setting
- Closing the settings menu
- _
- Buzzer volume
- Keypad tone
- Welcome tone
- Consumption
- Code
- Units
- Brightness
- Disp. switch-off stat.
- Programme info
- Memory
- Long p-wash Cotton
- Soak duration
- Gentle action
- Temp. reduction
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Low water pressure
- Anti-crease
- Miele@home
- _
- SmartGrid
- RemoteUpdate
- Copyrights and licences for the communication module
- Detergents and care products
Extra options
46
Extra options can be selected
using the Extrassensor control
Selecting extra options in the display
Touch theExtras sensor control.
The following appears in the display:No
Extras
Touch the sensor controls until
the extra option you want appears in
the display.
Confirm the extra option with the
OKsensor control.
The extra option will be given a next
to it.
Deselecting an extra option
Touch theExtras sensor control.
The first extra option which can be se-
lected appears in the display.
Touch the sensor controls until
No Extras appears in the display.
Confirm No Extras with the OKsensor
control.
The previously selected extra option is
now deselected.
Pre-wash
For laundry with large amounts of dirt,
e.g. dust and sand.
Soak
For heavily soiled and stained items
with protein stains.
A duration of between 30minutes and
6hours in 30-minute increments can be
selected for the soak process. See
“Settings” for more information.
The factory default setting is
30minutes.
Intensive
For hard-wearing laundry that is very
heavily soiled. Cleaning efficiency is in-
creased through more intense mechan-
ical action and the application of more
heat energy.
Extra quiet
This option reduces noise levels during
the wash programme. Use this if you
want to wash during quiet periods (for
instance when children are sleeping).
The final spin is automatically reduced
to (Rinse hold). The programme
duration is increased.
Extra gentle
Drum rotation and wash duration are re-
duced. Lightly soiled fabrics are
washed more gently.
AllergoWash
This option should be used where high
standards of hygiene are required. En-
ergy consumption is increased to
lengthen temperature holding times and
water consumption is increased to im-
prove rinsing efficiency. The items must
be suitable for drying in a tumble
dryer and suitable for ironing
.










