User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Delay start/SmartStart
- Programme chart
- Extra options
- Garment care label symbols
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Water hardness levels
- Dispensing aids
- Refill packs of detergent
- Colour run and dye removers/dyes
- Fabric conditioner and liquid starch
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Replacing the TwinDos cartridge
- Cleaning and care
- Problem solving guide
- The programme does not start
- The programme is cancelled and a fault indicator light lights up in the control panel
- During the programme sequence, a symbol appears in the time display
- At the end of the programme, an indicator light lights up in the control panel
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Programmable functions
- Opening the programming level
- Choosing and selecting a programmable function
- Editing and saving a programmable function
- Exit programming level
- Sensor tone
- Lock code
- Control panel switch-off status
- Memory
- Longer pre-wash Cottons
- Gentle action
- Reduce temperature
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Backlight brightness dimmed
- TwinDos
- UltraPhase 1 dispensing quantity
- UltraPhase 2 dispensing quantity
- TwinDos maintenance
- Degree of soiling
- Networking
- Remote control
- SmartGrid
- RemoteUpdate
- Switching off WiFi
- Copyrights and licences for the communication module
- Detergents and care products
Programmable functions
84
Memory
The washing machine will save the
last settings (temperature, spin speed
and some of the extras) selected for a
programme after the programme has
started.
When this programme is chosen again,
these saved settings will appear in the
display.
Options
= Memory is switched off (fact-
ory default setting)
= Memory is switched on
Longer pre-wash Cottons
If you require a longer pre-wash you
can extend the pre-wash time.
Options
= No increase in the pre-wash
time (factory default setting)
= + 6minutes increase in the
pre-wash time
= + 9minutes increase in the
pre-wash time
= + 12minutes increase in the
pre-wash time
Gentle action
Activating gentle action reduces the
drum action and is suitable for wash-
ing lightly soiled items more gently.
Gentle action can be activated for the
Cottons and Minimum iron pro-
grammes.
Options
= Gentle action is switched off
(factory default setting)
= Gentle action rhythm is
switched on
Reduce temperature
The boiling point for water is lower at
high altitudes. In order to avoid water
boiling, Miele recommend activating
the reduce temperature setting at alti-
tudes of more than 2000m above sea
level. The maximum temperature is re-
duced to 80°C even when a higher
temperature is selected.
Options
= The reduce temperature setting
is switched off (factory default
setting)
= The reduce temperature setting
is turned on