User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Delay start/SmartStart
- Programme chart
- Extra options
- Garment care label symbols
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Water hardness levels
- Dispensing aids
- Refill packs of detergent
- Colour run and dye removers/dyes
- Fabric conditioner and liquid starch
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Replacing the TwinDos cartridge
- Cleaning and care
- Problem solving guide
- The programme does not start
- The programme is cancelled and a fault indicator light lights up in the control panel
- During the programme sequence, a symbol appears in the time display
- At the end of the programme, an indicator light lights up in the control panel
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Programmable functions
- Opening the programming level
- Choosing and selecting a programmable function
- Editing and saving a programmable function
- Exit programming level
- Sensor tone
- Lock code
- Control panel switch-off status
- Memory
- Longer pre-wash Cottons
- Gentle action
- Reduce temperature
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Backlight brightness dimmed
- TwinDos
- UltraPhase 1 dispensing quantity
- UltraPhase 2 dispensing quantity
- TwinDos maintenance
- Degree of soiling
- Networking
- Remote control
- SmartGrid
- RemoteUpdate
- Switching off WiFi
- Copyrights and licences for the communication module
- Detergents and care products
Programmable functions
81
The programmable functions are used
to alter the washing machine’s elec-
tronics to suit changing requirements.
Programmable functions can be
altered at any time.
Opening the programming
level
Programming is carried out in 8steps
(, , ...) using the sensor con-
trols.
Prerequisites:
- The washing machine is switched on
(the programme selector is pointing
to a wash programme).
- The washing machine door is open.
Touch the Start/Add laundrysensor
control and hold it down while carry-
ing out steps –.
Close the washing machine door.
Wait until the Start/Add laundry sensor
control lights up constantly...
...and then release the Start/Add
laundry sensor control.
After approximately 4seconds, will
light up on the time display.
Choosing and selecting a pro-
grammable function
The number of the programmable
function will appear in the time display
as and a number: e.g..
Touch the or sensor control to
scroll to the next or previous pro-
grammable function:
Programmable functions
Keypad tone
PIN code
Control field switch-off behaviour
Memory
Additional long pre-wash – Cottons
Gentle action
Reduced temperature
Maximum rinse level
Suds cooling
Anti-crease
Low water pressure
Display brightness dimmed
TwinDos
Dosage quantity UltraPhase 1
Dosage quantity UltraPhase 2
TwinDos maintenance
Degree of soiling
Remote control
SmartGrid
RemoteUpdate
Confirm the selected programmable
function by touching theStart/Add
laundry sensor control.