User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Delay start/SmartStart
- Programme chart
- Extra options
- Garment care label symbols
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Water hardness levels
- Dispensing aids
- Refill packs of detergent
- Colour run and dye removers/dyes
- Fabric conditioner and liquid starch
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Replacing the TwinDos cartridge
- Cleaning and care
- Problem solving guide
- The programme does not start
- The programme is cancelled and a fault indicator light lights up in the control panel
- During the programme sequence, a symbol appears in the time display
- At the end of the programme, an indicator light lights up in the control panel
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Programmable functions
- Opening the programming level
- Choosing and selecting a programmable function
- Editing and saving a programmable function
- Exit programming level
- Sensor tone
- Lock code
- Control panel switch-off status
- Memory
- Longer pre-wash Cottons
- Gentle action
- Reduce temperature
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Backlight brightness dimmed
- TwinDos
- UltraPhase 1 dispensing quantity
- UltraPhase 2 dispensing quantity
- TwinDos maintenance
- Degree of soiling
- Networking
- Remote control
- SmartGrid
- RemoteUpdate
- Switching off WiFi
- Copyrights and licences for the communication module
- Detergents and care products
Problem solving guide
56
At the end of the programme, an indicator light lights up in the
control panel
Problem Cause and remedy
The indicator light
lights up.
Excessive foam has built up during washing.
Use less detergent next time and follow the manu-
facturer’s instructions on dosage given on the
packaging.
The indicator light
lights up and appears
on the time display.
When washing, a wash programme using a temperat-
ure above 60°C has not been run for a long time.
Run the Cottons90°C programme using Miele
machine cleaner or a multi-purpose powder deter-
gent.
This will clean the washing machine and prevent a
build-up of bacteria and odours.
and appear altern-
ately on the time dis-
play.
The Pre-ironingextra which runs at the end of the
programme could not be carried out properly.
Check whether the washing machine is aligned
correctly (see “Installation – Levelling the ma-
chine”).
Check whether the maximum drainage head
height of 1m has been exceeded.
If the fault message appears again, contact the Miele
Customer Service Department. The washing machine
can still be used, but without the Pre-ironing extra.