User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Delay start/SmartStart
- Programme chart
- Extra options
- Garment care label symbols
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Water hardness levels
- Dispensing aids
- Refill packs of detergent
- Colour run and dye removers/dyes
- Fabric conditioner and liquid starch
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Replacing the TwinDos cartridge
- Cleaning and care
- Problem solving guide
- The programme does not start
- The programme is cancelled and a fault indicator light lights up in the control panel
- During the programme sequence, a symbol appears in the time display
- At the end of the programme, an indicator light lights up in the control panel
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Programmable functions
- Opening the programming level
- Choosing and selecting a programmable function
- Editing and saving a programmable function
- Exit programming level
- Sensor tone
- Lock code
- Control panel switch-off status
- Memory
- Longer pre-wash Cottons
- Gentle action
- Reduce temperature
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Backlight brightness dimmed
- TwinDos
- UltraPhase 1 dispensing quantity
- UltraPhase 2 dispensing quantity
- TwinDos maintenance
- Degree of soiling
- Networking
- Remote control
- SmartGrid
- RemoteUpdate
- Switching off WiFi
- Copyrights and licences for the communication module
- Detergents and care products
Changing the programme sequence
44
Changing a programme (safety
lock)
A programme, temperature, spin speed
or selected options cannot be changed
once the machine has been success-
fully started. This prevents the machine
being operated unintentionally, e.g. by
children.
If the washing machine is switched off
during active programme operation,
the standby function does not switch
the washing machine off completely
after 15minutes. Safety functions
continue to be active because there
may still be water inside the drum.
Cancelling a programme
You can cancel a programme at any
time after it has started.
Turn the programme selector to the
position.
Turn the programme selector to any
position.
Rotating bars ...... or
are shown on the time display.
The water is pumped away and the
door lock is then released.
Selecting a new programme
Turn the programme selector to the
required programme.
Check that there is still detergent in
the detergent drawer. Add more de-
tergent if there is none left.
Touch theStart/Add laundry sensor
control.