User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Delay start/SmartStart
- Programme chart
- Extra options
- Garment care label symbols
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Water hardness levels
- Dispensing aids
- Refill packs of detergent
- Colour run and dye removers/dyes
- Fabric conditioner and liquid starch
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Replacing the TwinDos cartridge
- Cleaning and care
- Problem solving guide
- The programme does not start
- The programme is cancelled and a fault indicator light lights up in the control panel
- During the programme sequence, a symbol appears in the time display
- At the end of the programme, an indicator light lights up in the control panel
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Programmable functions
- Opening the programming level
- Choosing and selecting a programmable function
- Editing and saving a programmable function
- Exit programming level
- Sensor tone
- Lock code
- Control panel switch-off status
- Memory
- Longer pre-wash Cottons
- Gentle action
- Reduce temperature
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Backlight brightness dimmed
- TwinDos
- UltraPhase 1 dispensing quantity
- UltraPhase 2 dispensing quantity
- TwinDos maintenance
- Degree of soiling
- Networking
- Remote control
- SmartGrid
- RemoteUpdate
- Switching off WiFi
- Copyrights and licences for the communication module
- Detergents and care products
5. Add detergent
26
There are several options for adding de-
tergent.
The washing machine has the TwinDos
system.
TwinDos has to be activated as de-
scribed in “Before using for the first
time”.
The TwinDos system can only be op-
erated with the Miele UltraPhase1
and UltraPhase2 detergents.
How UltraPhase1 and UltraPhase2
work
UltraPhase1 is a liquid detergent which
dissolves dirt and removes the most
common stains. UltraPhase2 is a
bleaching agent and removes stubborn
stains. For the best washing result,
these two agents are dispensed at sep-
arate times during the washing process.
UltraPhase1 and UltraPhase2 clean
white and coloured fabrics thoroughly.
UltraPhase1 and UltraPhase2 single-
use cartridges are available to order
from Miele, your Miele dealer or via the
Miele online shop.
Activating TwinDos dispensing
TwinDos dispensing is automatically ac-
tivated for all programmes in which dis-
pensing is possible.
The TwinDos colourssensor control
lights up. The Twin Dos whitessensor
control lights up dimly in certain wash
programmes.
Tip: The detergent dispensing quanti-
ties are preset. If too much foam builds
up, you can reduce the dispensing
quantities using the and pro-
grammable functions.
Changing TwinDos dispensing
You can change the suggested colour
composition of the laundry.
- TwinDosWhitessensor control for
white or light fabrics
- TwinDosColourssensor control for
colour fabrics
The brightly lit sensor control is activ-
ated.
Touch theTwinDosWhites sensor
control if required.
Deactivating TwinDos dispensing
Touch the brightly lit Twin Dos whites
or TwinDos colours sensor control.
Both sensor controls light up dimly and
dispensing is deactivated.