User manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Operating the washing machine
- Caring for the environment
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Load the washing machine
- 3. Select a programme
- 4. Add detergent
- 5. Start the programme
- 6. End of programme
- Spinning
- Delay start
- Programme chart
- Extra options
- Garment care label symbols
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Water hardness levels
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Using fabric conditioner or starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- The programme is cancelled and a fault indicator light lights up in the control panel
- During the programme, a symbol appears in the time display
- At the end of the programme, an indicator light lights up in the control panel
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Consumption data
- Technical data
- Programmable functions
- Opening the programming level
- Choosing and selecting a programmable function
- Editing and saving a programmable function
- Exit programming level
- Keypad tone
- Lock code
- _
- Memory
- Longer pre-wash Cottons
- Soak duration
- Gentle action
- Reduce temperature
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Detergents and care products
Programmable functions
75
Reduce temperature
The boiling point for water is lower at
high altitudes. In order to avoid water
boiling, Miele recommend activating
the reduce temperature setting at alti-
tudes of more than 2000m above sea
level. The maximum temperature is re-
duced to 80°C even when a higher
temperature is selected.
Options
= The reduce temperature setting
is switched off (factory default
setting)
= The reduce temperature setting
is turned on
Water plus
You can determine the amount of wa-
ter used if the Water + extra is selec-
ted.
Selection
= More water is used in the wash
and rinse stages (factory de-
fault setting)
= An extra rinse is carried out
= The water level in the wash
and rinse stages is increased
and an extra rinse is carried
out
Water plus level
There are three different water levels
which can be selected by activating
the Water + extra.
Options
= No higher water level (factory
default setting)
= Water level increase by 1level
when washing and rinsing
= Water level increase by 2levels
when washing and rinsing
= Water level increase by 3levels
when washing and rinsing
Maximum rinse level
The water level in the rinse cycle can
be permanently set to the highest
value.
This function is useful for allergy suffer-
ers as it achieves an excellent rinse res-
ult. Water consumption will increase.
Options
= Maximum rinse level is
switched off (factory default
setting)
= Maximum rinse level is
switched on