User manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Operating the washing machine
- Caring for the environment
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Load the washing machine
- 3. Select a programme
- 4. Add detergent
- 5. Start the programme
- 6. End of programme
- Spinning
- Delay start
- Programme chart
- Extra options
- Garment care label symbols
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Water hardness levels
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Using fabric conditioner or starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- The programme is cancelled and a fault indicator light lights up in the control panel
- During the programme, a symbol appears in the time display
- At the end of the programme, an indicator light lights up in the control panel
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Consumption data
- Technical data
- Programmable functions
- Opening the programming level
- Choosing and selecting a programmable function
- Editing and saving a programmable function
- Exit programming level
- Keypad tone
- Lock code
- _
- Memory
- Longer pre-wash Cottons
- Soak duration
- Gentle action
- Reduce temperature
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Detergents and care products
Programmable functions
73
Lock code
The lock code prevents the washing
machine being used without your
knowledge.
When the code has been activated, you
have to enter a code after switching the
washing machine on. Otherwise the
washing machine cannot be operated.
Options
= Lock code switched off (fact-
ory default setting)
= Lock code is switched on
Using the washing machine with a
PIN code
The code is 125 and cannot be altered.
Switch on the washing machine.
The time display shows and
flashes to prompt you to enter the code.
Touch the sensor control.
appears on the time display.
Confirm the number with the
sensor control.
The first number has been saved and
you can now enter the second number
using the sensor control.
Enter the second and third numbers
and confirm the numbers with the
sensor control.
The lock function is deactivated. A
wash programme can now be selected
and started.
Indicator switch-off behaviour
The indicators will switch off after
10minutes to save energy.
Options
= Off (factory default setting)
The indicators will remain lit up
while the washing machine is
switched on.
= On
The indicators will switch off
after 10minutes if the pro-
gramme is started.
However, the indicators will re-
main lit up for 10minutes after
a Delay start time has elapsed,
after the end of a programme
or at the end of the anti-crease
phase.