User manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Operating the washing machine
- Caring for the environment
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Load the washing machine
- 3. Select a programme
- 4. Add detergent
- 5. Start the programme
- 6. End of programme
- Spinning
- Delay start
- Programme chart
- Extra options
- Garment care label symbols
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Water hardness levels
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Using fabric conditioner or starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- The programme is cancelled and a fault indicator light lights up in the control panel
- During the programme, a symbol appears in the time display
- At the end of the programme, an indicator light lights up in the control panel
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Consumption data
- Technical data
- Programmable functions
- Opening the programming level
- Choosing and selecting a programmable function
- Editing and saving a programmable function
- Exit programming level
- Keypad tone
- Lock code
- _
- Memory
- Longer pre-wash Cottons
- Soak duration
- Gentle action
- Reduce temperature
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Detergents and care products
Problem solving guide
47
The programme is cancelled and a fault indicator light lights up
in the control panel
Problem Cause and remedy
The fault indicator light
lights up, and ap-
pear alternately in the
time display and the
buzzer sounds.
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
Clean the drain filter and the drain pump.
The maximum delivery head is 1m.
The fault indicator light
lights up, and ap-
pear alternately in the
time display and the
buzzer sounds.
The water inlet is blocked or restricted.
Check whether the stopcock is opened properly.
Check whether the inlet hose is kinked.
Check whether the water pressure is too low.
The filter in the water inlet is blocked.
Clean the filter.
The fault indicator light
lights up, and
appear alternately in the
time display and the
buzzer sounds.
The water protection system has reacted.
Close the stopcock.
Call the Service Department.
and appear altern-
ately on the time display
and the buzzer sounds.
There is a fault.
Disconnect the washing machine from the electri-
city supply. Switch off at the wall and withdraw the
plug from the socket, or disconnect the fuse.
Wait at least 2minutes before reconnecting the
washing machine to the electricity supply.
Switch the washing machine on again.
Restart the programme.
If the fault message appears again, contact the
Miele Customer Service Department.