User manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Operating the washing machine
- Caring for the environment
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Load the washing machine
- 3. Select a programme
- 4. Add detergent
- 5. Start the programme
- 6. End of programme
- Spinning
- Delay start
- Programme chart
- Extra options
- Garment care label symbols
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Water hardness levels
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Using fabric conditioner or starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- The programme is cancelled and a fault indicator light lights up in the control panel
- During the programme, a symbol appears in the time display
- At the end of the programme, an indicator light lights up in the control panel
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Consumption data
- Technical data
- Programmable functions
- Opening the programming level
- Choosing and selecting a programmable function
- Editing and saving a programmable function
- Exit programming level
- Keypad tone
- Lock code
- _
- Memory
- Longer pre-wash Cottons
- Soak duration
- Gentle action
- Reduce temperature
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Detergents and care products
Delay start
29
With Delay start you can choose when
you want the programme to start. You
can delay the start of the programme by
30minutes up to a maximum of 24
hours, allowing you to make use of
night-time economy electricity rates, for
example.
Selecting the Delay start function
Delay start is not possible in the Drain/
Spin and Proofingprogrammes.
Select the programme required.
Touch the sensor control.
The symbol lights up brightly and
the first 30minutes of the Delay start
time appear on the time display.
Touch the sensor control re-
peatedly until the required Delay start
time lights up on the time display.
- In the case of settings below 3hours,
the Delay start time changes in incre-
ments of 30minutes.
- In the case of settings above 3hours,
the Delay start time changes in incre-
ments of 1hour.
Tip: If you press and hold the sensor
control, the time automatically counts
up to 24hours.
Starting Delay start
Touch the sensor control.
The Delay start process starts and
counts down on the time display.
Changing or cancelling a started
Delay start
If the selected Delay start function has
started, it is no longer possible to
change the time.
Turn the programme selector to the
position.
Turn the programme selector to any
programme.
Rotating bars ...... are
shown on the time display.
The door lock is released.
Select a programme and a new Delay
start time.