User manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Operating the washing machine
- GuideLine
- Caring for the environment
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Load the washing machine
- 3. Select a programme
- 4. Add detergent
- 5. Start the programme
- 6. End of programme - unload the drum
- Spinning
- Delay start
- Programme chart
- Extra options
- Garment care label symbols
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Water hardness levels
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- The programme is cancelled and a fault indicator light lights up in the control panel
- During the programme, a symbol appears in the time display
- At the end of the programme, an indicator light lights up in the control panel
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- After sales service
- Installation
- Technical data
- Consumption data
- Programmable functions
- Choosing and selecting a programmable function
- Editing and saving a programmable function
- Exit programming level
- Buzzer duration
- Buzzer
- Sensor tone
- Lock code
- Switch-off tone volume
- Control panel switch-off status
- Memory
- Longer pre-wash Cottons
- Soak duration
- Gentle action
- Reduce temperature
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Backlight brightness dimmed
- Welcome tone
- Operating hours
- Factory default
- Optional accessories
Programmable functions
81
Low water pressure
If the water pressure is below 100kPa
(1bar), the washing machine cancels
the programme and the fault mes-
sage appears.
If the water pressure cannot be in-
creased, activating this function will
prevent the programme from being can-
celled.
Options
= Low water pressure is
switched off
= Low water pressure is
switched on
Backlight brightness
dimmed
The brightness of the dimmed sensors
in the control panel can be set to one
of seven different levels.
The brightness changes as soon as you
select a different setting.
Options
= Darkest level
= Lightest level
Welcome tone
The welcome tone sounds whenever
the washing machine is switched on.
You can activate or deactivate the wel-
come tone.
Selection
= Welcome tone is deactivated
= Welcome tone is switched on
at normal volume
= Welcome tone is switched on
at loud volume
Operating hours
You can read off how many hours the
washing machine has been in opera-
tion for.
The total washing time is shown on the
time display in single digits. The wash-
ing machine has been in operation for
1234hours, for example. The figure
show on the time display will start with
an followed by a, then a and after
this a and a. The letter is dis-
played again after this.
Factory default
All programmable functions except
operating hours are reset to the
factory default settings.
Options
= Go back (without reset to fact-
ory default settings)
= Reset programmable functions
to the factory default settings