User manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Operating the washing machine
- GuideLine
- Caring for the environment
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Load the washing machine
- 3. Select a programme
- 4. Add detergent
- 5. Start the programme
- 6. End of programme - unload the drum
- Spinning
- Delay start
- Programme chart
- Extra options
- Garment care label symbols
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Water hardness levels
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- The programme is cancelled and a fault indicator light lights up in the control panel
- During the programme, a symbol appears in the time display
- At the end of the programme, an indicator light lights up in the control panel
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- After sales service
- Installation
- Technical data
- Consumption data
- Programmable functions
- Choosing and selecting a programmable function
- Editing and saving a programmable function
- Exit programming level
- Buzzer duration
- Buzzer
- Sensor tone
- Lock code
- Switch-off tone volume
- Control panel switch-off status
- Memory
- Longer pre-wash Cottons
- Soak duration
- Gentle action
- Reduce temperature
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Backlight brightness dimmed
- Welcome tone
- Operating hours
- Factory default
- Optional accessories
Programmable functions
78
Control panel switch-off
status
To save energy the time display and
sensors will go out after 10minutes,
and only the Start/Add laundry sensor
will flash slowly.
Options
= Off
The time display and sensors
will remain lit up while the
washing machine is switched
on
= On
The time display and sensors
will switch off after 10minutes
if the programme is started.
However; the time display and
sensors will remain lit up for
10minutes after a delay start
time has elapsed, after the end
of the programme or at the end
of the anti-crease phase.
Memory
The washing machine will save the
last settings (temperature, spin speed
and some of the extras) selected for a
programme after the programme has
started.
When this programme is chosen again,
these saved settings will appear in the
display.
Options
= Memory is switched off
= Memory is switched on
Longer pre-wash Cottons
If you require a longer pre-wash you
can extend the pre-wash time.
Options
= No increase in the pre-wash
time
= + 6minutes increase in the
pre-wash time
= + 9minutes increase in the
pre-wash time
= + 12minutes increase in the
pre-wash time