User manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Operating the washing machine
- GuideLine
- Caring for the environment
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Load the washing machine
- 3. Select a programme
- 4. Add detergent
- 5. Start the programme
- 6. End of programme - unload the drum
- Spinning
- Delay start
- Programme chart
- Extra options
- Garment care label symbols
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Water hardness levels
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- The programme is cancelled and a fault indicator light lights up in the control panel
- During the programme, a symbol appears in the time display
- At the end of the programme, an indicator light lights up in the control panel
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- After sales service
- Installation
- Technical data
- Consumption data
- Programmable functions
- Choosing and selecting a programmable function
- Editing and saving a programmable function
- Exit programming level
- Buzzer duration
- Buzzer
- Sensor tone
- Lock code
- Switch-off tone volume
- Control panel switch-off status
- Memory
- Longer pre-wash Cottons
- Soak duration
- Gentle action
- Reduce temperature
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Backlight brightness dimmed
- Welcome tone
- Operating hours
- Factory default
- Optional accessories
Problem solving guide
48
Minor faults in the performance of the washing machine, some of which may result
from incorrect operation, can be put right without contacting the Service Depart-
ment.
The following guide may help you to find the reason for a fault, and to correct it.
You should, however, note the following:
Repair work to electrical appliances should only be carried out by a suitably
qualified person in strict accordance with current local and national safety regu-
lations. Repairs and other work by unqualified persons could be dangerous. The
manufacturer cannot be held liable for unauthorised work.
The programme does not start
Problem Cause and remedy
The control panel re-
mains dark.
There is no power to the machine.
Check whether the mains plug is plugged in and
switched on.
Check whether the fuse or circuit breaker has
tripped.
The washing machine has switched off automatically
to save energy.
Switch the washing machine on again by turning
the programme selector.
and alternately ap-
pear in the time display.
The door is not closed properly. The door lock could
not engage.
Close the door again.
Start the programme again.
If the fault message appears again, contact the
Service Department.