User manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Operating the washing machine
- GuideLine
- Caring for the environment
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Load the washing machine
- 3. Select a programme
- 4. Add detergent
- 5. Start the programme
- 6. End of programme - unload the drum
- Spinning
- Delay start
- Programme chart
- Extra options
- Garment care label symbols
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Water hardness levels
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- The programme is cancelled and a fault indicator light lights up in the control panel
- During the programme, a symbol appears in the time display
- At the end of the programme, an indicator light lights up in the control panel
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- After sales service
- Installation
- Technical data
- Consumption data
- Programmable functions
- Choosing and selecting a programmable function
- Editing and saving a programmable function
- Exit programming level
- Buzzer duration
- Buzzer
- Sensor tone
- Lock code
- Switch-off tone volume
- Control panel switch-off status
- Memory
- Longer pre-wash Cottons
- Soak duration
- Gentle action
- Reduce temperature
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Backlight brightness dimmed
- Welcome tone
- Operating hours
- Factory default
- Optional accessories
Changing the programme sequence
40
Changing a programme or
adding/removing laundry
After the successful start of a pro-
gramme it is no longer possible to se-
lect a different programme.
After the start of a programme it is no
longer possible to open the door.
If you would like to change the pro-
gramme or add/remove laundry, you
must cancel the programme.
Cancelling a programme
You can cancel a programme at any
time after it has started:
Touch the Start/Stop sensor.
The water is pumped out, the time dis-
play changes to :. As soon as the
symbol goes out in the control panel,
the programme has been cancelled and
the door can be opened.
Selecting a different programme after
cancelling the programme
Open the door.
Close the door.
Check that there is still detergent in
the dispenser drawer. Add more de-
tergent if necessary.
Turn the programme selector to the
programme you want and start it by
pressing the Start/Stop sensor.
Removing laundry after cancelling
the programme
If you want to remove the laundry when
it is dripping wet:
Open the door.
Remove the laundry.
If you want to remove the laundry after
it has been spun (damp):
Open the door.
Close the door.
Turn the programme selector to
Drain/Spin.
Tip: Select an appropriate spin speed.
Touch the Start/Stop sensor.
The laundry is spun and after spinning,
it can be removed, damp.
Interrupting a programme
Turn the programme selector to the
position.
The washing machine switches off.
To continue: turn the programme se-
lector to the position of the wash pro-
gramme that was started.
Tip: If appears in the time display,
the programme selector is in the incor-
rect position.