User manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Operating the washing machine
- GuideLine
- Caring for the environment
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Load the washing machine
- 3. Select a programme
- 4. Add detergent
- 5. Start the programme
- 6. End of programme - unload the drum
- Spinning
- Delay start
- Programme chart
- Extra options
- Garment care label symbols
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Water hardness levels
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- The programme is cancelled and a fault indicator light lights up in the control panel
- During the programme, a symbol appears in the time display
- At the end of the programme, an indicator light lights up in the control panel
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- After sales service
- Installation
- Technical data
- Consumption data
- Programmable functions
- Choosing and selecting a programmable function
- Editing and saving a programmable function
- Exit programming level
- Buzzer duration
- Buzzer
- Sensor tone
- Lock code
- Switch-off tone volume
- Control panel switch-off status
- Memory
- Longer pre-wash Cottons
- Soak duration
- Gentle action
- Reduce temperature
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Backlight brightness dimmed
- Welcome tone
- Operating hours
- Factory default
- Optional accessories
Before using for the first time
18
Running the first programme
For optimum water and energy con-
sumption and excellent wash results, it
is important to calibrate the washing
machine.
To do this, the Cottonsprogramme
must be run without laundry and
without detergent.
Open the stopcock.
Turn the programme selector to Cot-
tons.
The washing machine is now switched
on and in the control panel, the temper-
ature 40°C lights up.
Touch the Start/Stop sensor.
The programme will start and the
symbol lights up in the control panel.
After 10minutes, the indicators dim
and the Start/Stop sensor starts flash-
ing.
At the end of the programme
At the end of the programme, the Anti-
crease function is switched on. The
symbol lights up in the control panel;
: appears in the time display and
the drum occasionally rotates.
Touch the Start/Stop sensor.
The door will unlock.
Reach under the door grip and pull
the door open.
Tip: Leave the door slightly open to al-
low the drum to dry.
When the programme has ended,
turn the programme selector to.
The washing machine is switched off
and is now ready for use.