Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the washing machine
- Initial commissioning
- Emptying the drum
- Switching on the washing machine
- Setting the display language
- Reference to external appliances
- Setting the display brightness
- Setting the date
- Confirming the time request
- Setting the time
- Selecting program packages
- Switching on automatic dispensing
- Setting up a payment system
- Selecting pre-wash water
- Selecting main wash water
- Removing the shipping struts
- Completing the commissioning process
- 1. Preparing the laundry
- 2. Loading the washing machine
- 3. Selecting a program
- 4. Selecting program settings
- 5. Adding detergent
- 6. Starting a program – end of a program
- Timer
- Program chart
- Extra options
- Special features in the program sequence
- Changing the program sequence
- Cleaning and care
- Frequently asked questions
- Technical Service
- MIELE
- Installation and connection
- Technical data
- Supervisor level
Supervisor level
95
Automatic dispensing
Automatic dispensing via an external
dispensing system can be activated
Factory default: Off
Adjustment value dispensing 1–6
To address the tolerances that occur
in the pump system over time, the dis-
pensing amount (ml/min) for the
pumps can be corrected.
The calibration value can be reduced by
3increments or increased by 3incre-
ments.
The calibration value is increased or re-
duced by 1, 2 or 3 times the adjustment
value based on the selected incremen-
tal setting.
The calibration value and the adjust-
ment value must be added to the data
for the dispenser pumps by Miele Cus-
tomer Service.
Peak load signal
External hardware is connected via the
Miele XCI Box.
The peak-load negotiation function
enables the washing machine to be
connected to an energy management
system. When a signal is registered,
the washing machine’s heater is
switched off for a short period.
The washing machine may only be op-
erated with a peak-load system if this
system is connected to the washing
machine via the Miele XCI Box.
- No function (factory default)
- Peak load with 230V
- Peak load with 0V
- Com module
Peak load prevention
The peak-load negotiation function
can be deactivated with disinfection
programs. When a signal is registered,
the washing machine’s heater is not
switched off.
Factory default: Off