Operating instructions/Installation instructions

Guide to the appliance
23
Fitting and removing FlexiClip run-
ners
 Risk of injury caused by hot sur-
faces.
The combination steam oven gets
hot during operation. You could burn
yourself on the heater elements,
oven compartment or accessories.
Allow the heater elements, oven
compartment and the accessories to
cool before fitting or removing the
FlexiClip runners.
The FlexiClip runners are fitted in
between the two rails that make up a
shelf level.
The FlexiClip runner with the Miele logo
should be fitted on the right.
When fitting or removing the FlexiClip
runners, do not extend them.
 Hook the FlexiClip runner onto the
front of the lower rail of a shelf
level(1.) and then push it along the
rail into the oven compartment(2.).
 Then secure the FlexiClip runner to
the lower rail of the shelf level(3.).
If the FlexiClip runners are difficult to
pull out after fitting, pull firmly on them
once to release them.
To remove a FlexiClip runner, proceed
as follows:
 Push the FlexiClip runner in all the
way.
 Remove the FlexiClip runner by rais-
ing it at the front(1.) and then pulling
it forwards along the rail of the shelf
level and out(2.).