Operating instructions/Installation instructions

Cleaning and care
94
Cleaning the door seal
 Risk of damage as a result of in-
correct cleaning.
If you treat the door seal with oils or
grease, it can become porous.
Do not use any oils or grease on the
door seal.
 The door seal should be cleaned reg-
ularly with clean water, and then
wiped dry with a soft cloth.
Cleaning the ventilation gaps
A build-up of dust will increase the en-
ergy consumption of the appliance.
 The ventilation gaps should be
cleaned on a regular basis with a
brush or vacuum cleaner (you could
use a Miele vacuum cleaner dusting
brush, for example).
Replacing the Active AirClean
filters
The Active AirClean filters in the refri-
gerator section need to be replaced ap-
prox. every 6 months.
Change Active AirClean filter will appear on
the display.
 Confirm the message with OK.
 To remove the holder for the Active
AirClean filters, press against the re-
tainers on both sides of the holder
from the rear and pull the holder
downwards diagonally from the
frame.
 Remove the used Active AirClean fil-
ters and place the new Active
AirClean filters with the surrounding
edge pointing downwards in the
holder.
 To replace the holder, press against
the retainers on both sides of the
holder from the rear and clamp it into
the gap on the frame from below.
The holder can be fixed under any
shelf in the refrigerator section.
Once the Active AirClean filters have
been replaced, the Active AirClean filter
display  must be reset using Settings
mode  on the display (see “Selecting
additional settings – Resetting the Dis-
play Active AirClean filter ”).
New Active AirClean filters can be ob-
tained from the Miele Customer Ser-
vice Department, your Miele dealer or
the Miele website.