Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Installation
- Location
- Installation notes
- Building-in dimensions
- Dimensions of the furniture front
- Installing the appliance
- Before starting ...
- Tools required
- Weight of the furniture front
- Aligning the building-in niche
- Checking the building-in niche
- Before installation
- Preparing the building-in niche
- Pushing the refrigeration appliance into the building-in niche
- Aligning the refrigeration appliance
- Securing the refrigeration appliance in the building-in niche
- Preparing to install the furniture fronts
- Securing and aligning the furniture front
- Mounting the fixing bracket
- Securing the covers
- Installing the cover in a side-by-side combination
- Securing the plinth ventilation grille and plinth panel
- Limiting the opening angle of the appliance door
- Electrical connection
- Saving energy
- Guide to the appliance
- Accessories
- Initial commissioning
- Switching on and off
- Selecting additional settings
- The correct temperature
- Using Super cool
- Door alarm
- Adjusting the interior fittings
- Storing food in the refrigerator section
- Storing food in the MasterFresh zone
- Automatic defrosting
- Cleaning and care
- Problem solving guide
- Noises
- Service
- EU Conformity declaration
- UK Conformity declaration
- Copyrights and Licences
Selecting additional settings
70
Activating Miele@home
If you have already activated
Miele@home and then disconnected
the connection, you will need to react-
ivate the connection.
In Settings mode, use the
and sensor controls to se-
lectMiele@home and selectOK to
confirm your selection.
Use the and sensor controls to
select Activate and select OK to con-
firm your selection.
Activation successful will appear on the
display.
Confirm the message with OK.
If the WiFi connection is active, will
appear on the display.
Checking the WiFi connection status
In Settings mode, use the
and sensor controls to se-
lectMiele@home and selectOK to
confirm your selection.
Use the and sensor controls to
select Connection status and select OK
to confirm your selection.
Information about the WiFi connection
status will then appear on the display:
- connected: there is a strong con-
nection
- connected: there is an average
connection
- connected: there is a weak con-
nection
- : disconnected
Setting up Miele@home again
If you have changed your WiFi network,
you can set up Miele@home again for
your refrigeration appliance.
In Settings mode, use the
and sensor controls to se-
lectMiele@home and selectOK to
confirm your selection.
Use the and sensor controls to
select Set up again and select OK to
confirm your selection.
Reset configuration?will appear on the
display.
Use the and sensor controls to
select Yes or No and select OK to
confirm your selection.
Resetting the network configuration
Reset the refrigeration appliance’s set-
tings to the default settings when dis-
posing of your refrigeration appliance,
selling it or putting a used refrigeration
appliance into operation. This will re-
set the network configuration so that
all personal data is deleted from the
refrigeration appliance. This will also
ensure that a previous owner is no
longer able to access the refrigeration
appliance.
Reset the settings of the refrigeration
appliance as described in the chapter
“Resetting the settings to their default
settings”.