Operating and Installation instructions

Installation
*INSTALLATION*
86
The appliance is only suitable for
connection to a cold water supply,
which
- is directly connected to the water
supply in order to ensure a circulation
of the water in the cold water line.
Avoid using a water line in which the
water is allowed to pool. This can af-
fect the taste of water and ice cubes.
- withstands the operating pressure.
- fulfills the hygiene regulations.
Water pressure on-site:
- Minimum: 21.76psi (1.5bar)
- Maximum: 87.02psi (6bar)
A shut-off valve must be provided be-
tween the water line and the water sup-
ply of the building to ensure that the
water supply can be cut off if neces-
sary.
Make sure that the shut-off valve is
still accessible after the appliance
has been installed.
 Risk of damage!
If the water supply is cut off while the
ice cube maker is still in use the wa-
ter intake pipe can freeze up.
Turn the ice cube maker off if the wa-
ter supply is interrupted (e.g. while
on vacation).
Before establishing the fresh water
connection, ensure that the appli-
ance is disconnected from the power
supply.
The fresh water connection is at the
back of the appliance, at the bottom.
The connection parts included with the
appliance permit the connection of vari-
ous water lines (water line not supplied).
Do not connect old water lines that
have been used before.
The solenoid valve has a metric
R3/4 connection thread.