Operating and Installation instructions

The correct temperature
22
Setting the temperature
 Use the two sensors below the dis-
play to set the temperature.
When you touch the sensor
- The temperature decreases.
- The temperature increases.
The temperature value flashes while the
temperature is being set.
The following information appears in the
display when the sensors are touched:
- With the first touch: The last temper-
ature set flashes.
- Each subsequent touch: The temper-
ature changes in 1°F increments.
- Keeping your finger on the sensor
changes the temperature continu-
ously.
Approximately 5seconds after the last
time a sensor was touched, the actual
temperature inside the appliance will
automatically be displayed.
Or
 Touch the OK button to confirm your
selection.
If you have adjusted the temperature,
wait for approximately 6hours if the
appliance is not very full and for ap-
proximately 24hours if the appliance
is full before checking the temperature
display. It will take this long for an accu-
rate reading to be given.
 If the temperature is still too high or
too low at the end of this time, adjust
it again.
Temperature range
The temperature can be adjusted from
5°F to -18°F (-15°C to -28°C).