Operating and Installation instructions

Switching on and off
19
Before first use
Packaging material
 Remove all packaging material from
the inside of the appliance.
Removing the protective film
 Carefully remove the protective film.
Cleaning the refrigerator
Please refer to the relevant instruc-
tions in “Cleaning and care”.
 Clean the inside of the appliance and
the accessories.
 Clean the ice cube maker: after se-
lecting the “Rinse ice cube maker”
setting; the ice cube maker and the
water supply pipework are rinsed au-
tomatically with water.
Operating the appliance
A light touch of the finger on the sen-
sors is all that is required to operate this
appliance.
A tone will sound each time a sensor is
touched. You can deactivate this if you
wish (see “Selecting additional settings
– Acoustic signals”).
Switching on the appliance
To enable the internal temperature to
get sufficiently cold, allow the appli-
ance to run for a few hours before
placing food inside it.
Once the appliance is connected to the
electricity supply, the power supply
symbol will soon appear in the dis-
play.
 Touch the On/Off button.
The appliance will start cooling. The
power connection symbol goes out
and the temperature appears in the dis-
play.
The temperature display and the alarm
symbol  will flash at the same time
until the required temperature is
reached. If the current temperature is
above 32°F (0°C), two bars will flash in
the display.
When the appliance door is opened, the
interior lighting comes on and the LED
lighting becomes brighter until it
reaches its maximum brightness.