Operating and Installation instructions

Features
27
Installing and removing the FlexiClips
with Wire Rack
 Danger of injury caused by hot
surfaces.
The oven gets hot during operation.
You could burn yourself on the
heater elements, oven compartment,
or accessories.
Allow the heating elements, oven
compartment, and the accessories to
cool down before installing or
removing the FlexiClips with Wire
Rack.
When installing or removing the
FlexiClips, do not extend them.
 Hold the FlexiClips with Wire Rack
with both hands and position them in
front of the desired level.
 Insert the FlexiClips with Wire Rack
onto the level (1.) and slide them
along the struts of the level (2.) until
they click into place.
If the FlexiClips are difficult to pull out
after installing, you may need to pull
firmly on them once to release them.
Tip: When using the universal tray,
place it directly on the FlexiClips with
Wire Rack.
To remove the FlexiClips with Wire
Rack, proceed as follows:
 Push the FlexiClips with Wire Rack in
all the way.
 Lift the front of the FlexiClips with
Wire Rack on both sides (1.) and pull
them out of the level (2.).
Temperature selector with °C scale
The range is delivered with a
temperature selector with °F scale. The
temperature selector with °C scale is
available as an optional accessory.
Please quote the model designation of
the range when ordering.
Replacing the temperature selector
Do not operate the range without a
temperature selector installed.
 Turn the temperature selector to the 
position.
 Pull the temperature selector off the
range horizontally.
 Install the new temperature selector
in the same position by pushing it
onto the range.