Operating instructions/Installation instructions

Operation
48
Display of program cycle time
The estimated duration of the selected
program appears in the display before
the program starts. During the program,
the time left until the end of the program
is displayed.
Each program phase is indicated by a
symbol:
 Pre-rinse/Soak
 Main wash
 Interim rinse
 Final rinse
 Drying
 Finish
The displayed duration may vary for the
same program. It is influenced by, for
example, the temperature of the incom-
ing water, the reactivation cycle of the
water softener, and the amount of dish-
ware and how soiled it is.
When a program is selected for the first
time, the display will show the average
cycle time for a hot water connection.
The program durations shown under
“Program overview” refer to standard
test loads and temperatures.
Each time a program is run, the control
module calculates the program duration
required depending on the temperature
of the water taken into the dishwasher
and the amount of dishware.
Starting a program
 Touch the Start sensor button.
Confirm the previously displayed
messages with OK.
The program starts.
The Start sensor button lights up.
During the program sequence, you
can use OK to display the name of the
program that is currently running.
 Risk of scalding due to hot wa-
ter.
During operation, water in the dish-
washer may be very hot.
During operation, only open the door
with extreme caution.