Operating instructions/Installation instructions

Initial commissioning
25
Setting the time
The time is updated automatically if a
connection is established with the
WiFi network.
The display will then change to the
screen for setting the time.
The current time of day must be set be-
fore you can use the timer option.
 Use the sensor buttons to enter
the hour and confirm your entry with
OK.
 Then set the minutes and confirm
with OK.
Keeping the relevant or sensor
button pressed will increase or de-
crease the time automatically.
Setting water hardness
The display changes to the screen for
setting the water hardness.
- The dishwasher must be pro-
grammed to the correct water hard-
ness for your area.
- Your local water authority will be able
to advise you of the water hardness
level in your area.
- Where the water hardness fluctuates,
e.g., between 10 and 16gr/gal (10–
15°dH – German scale), always pro-
gram the dishwasher to the higher
value (16gr/gal or 15°dH in this ex-
ample).
It is useful to know your water hardness
so that you can provide the service
technician with this information in the
event of any service calls.
Enter the water hardness below:
____________ gpg (°dH)
The dishwasher is programmed at the
factory for a water hardness level of 15
gpg (14°dH).
 Set the water hardness level in your
area and confirm with OK.
See “Water hardness” under “Set-
tings” for more information.