Product datasheet
Shine 40
ProCare
Rinsing agent
Use
ProCare Shine 40 is a liquid rinsing agent (liquid concentrate) for machine cleaning of dishes in
commercial dishwashers with fresh water or tank systems.
Product features
• Improves and shortens the drying process
• Prevents formation of limescale and protects loads
• Suitable for use with any load, including glass, aluminium and silver
• Protects decor
• Contains citric acid, tensides and complexing agents
ProCare Shine 40 is intended for commercial use only.
Use and dispensing
ProCare Shine 40 is designed for use in programmes in Miele Professional commercial dish-
washers.
• Precise and economical dispensing via the internal door dispenser or via an external dispensing
pump (depending on model of machine)
• Recommended dosage: 0.2 - 0.5 ml/l (0.02-0.05%)
• Recommended water hardness range: 0-3°dH (0-0.5 mmol/l)
The rinsing agent dosage should be set to suit the load. Dispensing too much or too little rinsing
agent can lead to unsatisfactory results. Adjustments can be made as necessary to the factory
default setting (generally 0.04% for Miele machines).
We recommend using soft water (0 – 3°dH / 0 - 0.5 mmol/l) in dishwashers. Harder water (up to
max. 8 °dH / 1.4 mmol/l) can be compensated for by setting a higher dispensing concentration.
To protect the dishwasher and the load we recommend the use of a water treatment system
(e.g. an internal or external water softening system) to achieve the water hardness range specified.
Please note:
• Do not mix with other products.
• When changing products, please note:
− When using an external dispensing pump the dispensing system must be rinsed through with
water and vented.
− When using the internal reservoir we recommend refilling with a new product only when the
rinsing agent refill reminder has appeared.
• Operating instructions for Miele Professional dishwashers must be observed.
Sparkling results
Water is a determining factor in the cleaning process according to Sinner. When
the wash load has been cleaned, there should be no visible trace of this process
remaining. The load should be largely dry, sparkling and free of residue. To achie-
ve this the water must run o as quickly as possible.
Adding rinsing agent reduces the surface tension of the water so that the water
runs o without forming droplets or streaks. Furthermore it also helps to bind any
substances in the water which might contribute to hardness, such as magnesium
and calcium ions, to avoid streaking.
The composition of the load also has a considerable influence on the drying process. Materials such
as glass, porcelain or stainless steel dry at varying speeds. Plastics in particular require a longer drying
process due to their low heat conductivity. The shape of the load also aects drying, e.g. if water
cannot run o easily.