Safety data sheet

Page 5/11
Safety Data Sheet
acc. to OSHA HCS
Printing date 11/15/2022 Reviewed on 11/15/2022
Trade name: Miele ProCare Shine 12GC Tabs
(Contd. of page 4)
55.2.5
ꞏ
Control parameters
ꞏ
Components with limit values that require monitoring at the workplace:
The following constituents are the only constituents of the product which have a PEL, TLV or other
recommended exposure limit.
At this time, the other constituents have no known exposure limits.
9004-34-6 Cellulose
PEL Long-term value: 15* 5** mg/m³
*total dust **respirable fraction
REL Long-term value: 10* 5** mg/m³
*total dust **respirable fraction
TLV Long-term value: 10 mg/m³
7757-82-6 Sodium sulphate
TLV Short-term value: NIC-0.2 mg/m³
thoracic fraction of aerosol
9014-01-1 Protease (Subtilisin)
REL Short-term value: 0.00006* mg/m³
*60-min
TLV Ceiling limit value: 0.00006 mg/m³
as 100% crystalline active pure enzyme
ꞏ
Additional information:
The lists that were valid during the creation were used as basis.
ꞏ
Exposure controls
ꞏ
Personal protective equipment:
ꞏ
General protective and hygienic measures:
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing.
Wash hands before breaks and at the end of work.
Avoid contact with the skin.
Avoid contact with the eyes and skin.
ꞏ
Breathing equipment:
Not required.
In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer
exposure use respiratory protective device that is independent of circulating air.
ꞏ
Protection of hands:
Protective gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the
preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the
preparation/ the chemical mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
ꞏ
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks
of quality and varies from manufacturer to manufacturer. As the product is a preparation of several
substances, the resistance of the glove material can not be calculated in advance and has
therefore to be checked prior to the application.
Butyl rubber, BR
(Contd. on page 6)
US/EN