Safety data sheet

according to 29 CFR 1910.1200(g)
Safety Data Sheet
ProCare Shine 10 MA
Revision date: 13.06.2018 Product code: Page 2 of 9
QuantityComponentsCAS No
< 2 %1310-73-2 sodium hydroxide
4. First-aid measures
Description of first aid measures
In case of accident or unwellness, seek medical advice immediately (show directions for use or safety data
sheet if possible).
General information
In case of accident by inhalation: remove casualty to fresh air and keep at rest. In case of respiratory tract
irritation, consult a physician.
After inhalation
Gently wash with plenty of soap and water. In case of skin irritation, seek medical treatment.
After contact with skin
Rinse cautiously with water for several minutes. In case of troubles or persistent symptoms, consult an
ophthalmologist.
After contact with eyes
Rinse mouth thoroughly with water. Let water be drunken in little sips ( dilution effect). Do NOT induce vomiting.
In all cases of doubt, or when symptoms persist, seek medical advice.
After ingestion
Most important symptoms and effects, both acute and delayed
refer to section 2 and 11.
Indication of any immediate medical attention and special treatment needed
Treat symptomatically.
5. Fire-fighting measures
Extinguishing media
Carbon dioxide (CO2) Dry extinguishing powder. alcohol resistant foam. Atomized water.
Suitable extinguishing media
High power water jet.
Unsuitable extinguishing media
Specific hazards arising from the chemical
Can be released in case of fire: Carbon monoxide, Carbon dioxide (CO2).
In case of fire: Wear self-contained breathing apparatus.
Special protective equipment and precautions for fire-fighters
Collect contaminated fire extinguishing water separately. Do not allow entering drains or surface water.
Co-ordinate fire-fighting measures to the fire surroundings.
Additional information
6. Accidental release measures
Personal precautions, protective equipment and emergency procedures
Do not breathe vapour/aerosol. Avoid contact with skin, eyes and clothes.
Wear personal protection equipment (refer to section 8).
High slip hazard because of leaking or spilled product.
Discharge into the environment must be avoided.
Environmental precautions
Absorb with liquid-binding material (e.g. sand, diatomaceous earth, acid- or universal binding agents).
Treat the recovered material as prescribed in the section on waste disposal .
Clean contaminated objects and areas thoroughly observing environmental regulations.
Methods and material for containment and cleaning up
Print date: 10.03.2020USA - ENRevision No: 2,0