User manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Guide to the machine
- Unpacking and installing
- Operation
- Before using for the first time
- Bean system
- Filling the water container
- Switching on and off
- Spout adjustment
- Cup heating
- Making coffee with and without milk
- Making coffee with milk
- Tea
- Dispensing hot water
- Parameters
- Portion size
- Resetting drinks
- Profiles
- Profiles: creating and processing drinks
- Profiles: making drinks
- Expert mode
- Settings
- Networking
- Cleaning and care
- Overview of cleaning intervals
- Cleaning by hand or in the dishwasher
- Unsuitable cleaning agents
- Clean the drip tray and waste container
- Cleaning the drip tray cover
- Cleaning the water container
- Removing and cleaning the water container filter
- Cleaning the central spout with integrated Cappuccinatore
- Removing and cleaning the cup sensor
- Cleaning the milk siphon
- Cleaning the milk flask
- Cleaning the milk pipework manually or using the maintenance programme
- Cleaning the bean system
- Ground coffee drawer cleaning
- Vacuuming out the ground coffee chute
- Cleaning the casing
- Maintenance programmes
- Rinsing the machine
- Rinsing the milk pipework
- Cleaning the milk pipework
- Degreasing the brew unit and cleaning the interior
- Descaling the machine
- Automatic descaling
- Problem solving guide
- Service
- Transporting the machine
- Accessories
- Saving energy
- Electrical connection
- Dimensions
- Technical data
- EU Conformity declaration
- UK Conformity declaration
Problem solving guide
90
Problem Cause and remedy
F233 The cup sensor is not inserted or is incorrectly
inserted.
The stainless steel cover of the central spout was not
fitted properly, e.g. is tilting forwards slightly.
If the central spout is moving upwards and the cup
sensor is bumped, e.g. with a cup, the cup sensor
loses its reference position.
Confirm the message with OK.
Switch the machine off with the On/Off sensor.
Wait for at least 30minutes before switching the
machine back on again. Or disconnect the
appliance from the electricity supply by switching
off at the wall socket and withdrawing the power
plug, or switching off the mains circuit breaker.
Refit the cup sensor.
Refit the stainless steel cover. Make sure the cover
is seated correctly.
F355, F357– F362 The bean system must be set up again, e.g. coffee
beans have possibly got jammed.
Switch the machine off with the On/Off sensor.
Wait for 30minutes before switching the machine
back on again.