User manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Guide to the machine
- Unpacking and installing
- Operation
- Before using for the first time
- Bean system
- Filling the water container
- Switching on and off
- Spout adjustment
- Cup heating
- Making coffee with and without milk
- Making coffee with milk
- Tea
- Dispensing hot water
- Parameters
- Portion size
- Resetting drinks
- Profiles
- Profiles: creating and processing drinks
- Profiles: making drinks
- Expert mode
- Settings
- Networking
- Cleaning and care
- Overview of cleaning intervals
- Cleaning by hand or in the dishwasher
- Unsuitable cleaning agents
- Clean the drip tray and waste container
- Cleaning the drip tray cover
- Cleaning the water container
- Removing and cleaning the water container filter
- Cleaning the central spout with integrated Cappuccinatore
- Removing and cleaning the cup sensor
- Cleaning the milk siphon
- Cleaning the milk flask
- Cleaning the milk pipework manually or using the maintenance programme
- Cleaning the bean system
- Ground coffee drawer cleaning
- Vacuuming out the ground coffee chute
- Cleaning the casing
- Maintenance programmes
- Rinsing the machine
- Rinsing the milk pipework
- Cleaning the milk pipework
- Degreasing the brew unit and cleaning the interior
- Descaling the machine
- Automatic descaling
- Problem solving guide
- Service
- Transporting the machine
- Accessories
- Saving energy
- Electrical connection
- Dimensions
- Technical data
- EU Conformity declaration
- UK Conformity declaration
Cleaning and care
71
Clean the surfaces of the central
spout with a damp cloth.
Clean any blockages in the milk
pipework under running water with the
special brush supplied:
Insert the brush in the pipework.
Move it back and forth until all milk
residue has been removed.
Reassembling the central spout
The dispensing unit is easier to
reassemble if the individual parts are
dampened with water beforehand.
Fit the dispensing unit back together.
Push the spouts firmly back onto
the dispensing unit.
Make sure that all parts are tightly
connected to one another.
Push the dispensing unit back into
the central spout and replace the
stainless steel cover.
Touch OK.
Tip: If the coffee machine is switched
off, the central spout components can
be removed and cleaned at any time.
Removing and cleaning the
cup sensor
The cup sensor is located under the
central spout.
Clean the cup edge sensor daily by
hand with warm water and a little
washing-up liquid.
Press the two retainers together (see
arrows).
The cup edge sensor is released.
Clean the cup edge sensor.
Refitting:
Press the cup edge sensor from
below into the holder on the central
spout.