User manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Guide to the machine
- Unpacking and installing
- Operation
- Before using for the first time
- Bean system
- Filling the water container
- Switching on and off
- Spout adjustment
- Cup heating
- Making coffee with and without milk
- Making coffee with milk
- Tea
- Dispensing hot water
- Parameters
- Portion size
- Resetting drinks
- Profiles
- Profiles: creating and processing drinks
- Profiles: making drinks
- Expert mode
- Settings
- Networking
- Cleaning and care
- Overview of cleaning intervals
- Cleaning by hand or in the dishwasher
- Unsuitable cleaning agents
- Clean the drip tray and waste container
- Cleaning the drip tray cover
- Cleaning the water container
- Removing and cleaning the water container filter
- Cleaning the central spout with integrated Cappuccinatore
- Removing and cleaning the cup sensor
- Cleaning the milk siphon
- Cleaning the milk flask
- Cleaning the milk pipework manually or using the maintenance programme
- Cleaning the bean system
- Ground coffee drawer cleaning
- Vacuuming out the ground coffee chute
- Cleaning the casing
- Maintenance programmes
- Rinsing the machine
- Rinsing the milk pipework
- Cleaning the milk pipework
- Degreasing the brew unit and cleaning the interior
- Descaling the machine
- Automatic descaling
- Problem solving guide
- Service
- Transporting the machine
- Accessories
- Saving energy
- Electrical connection
- Dimensions
- Technical data
- EU Conformity declaration
- UK Conformity declaration
Cleaning and care
70
Cleaning the central spout with
integrated Cappuccinatore
With the exception of the stainless steel
cover, all parts of the central spout
should be cleaned in the dishwasher at
least once a week. This will remove
coffee deposits and milk residues
effectively.
Clean the central spout stainless steel
cover by hand only using warm water
and a little washing-up liquid.
Start in the Drinks menu.
If the central spout is in the uppermost
position, it cannot be dismantled. The
central spout must be moved into the
maintenance position to do this.
Touch for 3seconds.
The central spout will move into the
maintenance position.
Carefully pull the stainless steel cover
off.
Remove the dispensing unit to the
front.
Twist off the upper section with the
holder for the milk pipe. Pull the
component off. Then pull the Y-
shaped piece off. Remove the
dispensing spouts.
Clean all parts thoroughly.