User manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Product description
- Controls and indicators
- Operation
- Miele@home
- Before using for the first time
- Filling the water container
- Filling the coffee bean container
- Switching on and off
- Cup heating
- Adjusting the central spout to the correct cup height
- Making drinks
- Expert mode
- Grinder setting
- Parameters
- Profiles
- MobileStart
- Settings
- Cleaning and care
- Overview of cleaning intervals
- Cleaning by hand or in the dishwasher
- Unsuitable cleaning agents
- Drip tray and waste container
- Cleaning the drip tray cover
- Water container
- Removing and cleaning the water container filter
- Dismantling and cleaning the central spout
- Cleaning the steam jet
- Cleaning the milk pipework and rinse valve
- Cleaning the milk siphon
- Cleaning the milk flask
- Bean container and ground coffee chute
- Cleaning the casing
- Opening the “Maintenance” menu
- _
- Rinsing the milk pipework
- Cleaning the milk pipework (maintenance programme)
- Degreasing the brew unit and cleaning the interior
- Descaling the machine
- Problem solving guide
- Transporting the machine
- After sales service and warranty
- Accessories
- Saving energy
- Electrical connection
- Installation
- Appliance dimensions
- Technical data
- EU Conformity declaration
- UK Conformity declaration
Problem solving guide
79
Unsatisfactory results
Problem Cause and remedy
The coffee is not hot
enough.
The cup has not been pre-heated.
The smaller the cup and the thicker its sides, the
more important it is to pre-heat it.
Pre-heat the cups, e.g. using the cup heating
(depending on model).
The brewing temperature has been set too low.
Set a higher brewing temperature.
The filters in the brew unit are blocked.
Remove the brew unit and clean it by hand.
Degrease the brew unit.
The heating-up time is
getting longer, the
amount of water being
dispensed is incorrect
and the coffee machine
is not performing prop-
erly. Coffee flows very
slowly out of the central
spout.
The coffee machine needs descaling.
Descale the coffee machine.
The quantity of dis-
pensed coffee has
changed.
The brew unit is blocked.
Degrease the brew unit (see “Cleaning and care –
Degreasing the brew unit and cleaning the
interior”).
The consistency of the
milk froth is unsatisfact-
ory.
The milk temperature is too high. Good milk froth can
only be achieved with cold milk (below 10°C).
Check the temperature of the milk in the milk flask.
The milk pipework is blocked.
Clean the central spout and milk pipework with the
brush.