User manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Product description
- Controls and indicators
- Operation
- Miele@home
- Before using for the first time
- Filling the water container
- Filling the coffee bean container
- Switching on and off
- Cup heating
- Adjusting the central spout to the correct cup height
- Making drinks
- Expert mode
- Grinder setting
- Parameters
- Profiles
- MobileStart
- Settings
- Cleaning and care
- Overview of cleaning intervals
- Cleaning by hand or in the dishwasher
- Unsuitable cleaning agents
- Drip tray and waste container
- Cleaning the drip tray cover
- Water container
- Removing and cleaning the water container filter
- Dismantling and cleaning the central spout
- Cleaning the steam jet
- Cleaning the milk pipework and rinse valve
- Cleaning the milk siphon
- Cleaning the milk flask
- Bean container and ground coffee chute
- Cleaning the casing
- Opening the “Maintenance” menu
- _
- Rinsing the milk pipework
- Cleaning the milk pipework (maintenance programme)
- Degreasing the brew unit and cleaning the interior
- Descaling the machine
- Problem solving guide
- Transporting the machine
- After sales service and warranty
- Accessories
- Saving energy
- Electrical connection
- Installation
- Appliance dimensions
- Technical data
- EU Conformity declaration
- UK Conformity declaration
Cleaning and care
58
2
Pull off the upper silicone section
with the aperture for the milk
pipework.
4
The grey silicone section contains a
black, cylindrical component. Pull
out the black component.
Remove the dispensing spouts.
Clean all parts thoroughly.
Clean the surfaces of the central
spout with a damp cloth.
To effectively remove coffee deposits,
clean the coffee pipework with the
cleaning brush once a month.
Angle the cleaning brush slightly and
clean both spouts from above and
below.
Reassembling the central spout
The dispensing unit is easier to
reassemble if the individual parts are
dampened with water.
Fit the dispensing unit back together.
Push the spouts firmly all the way
round so that the dispensing unit is
firmly seated in the groove.