Operating and Installation instructions

Frequently Asked Questions
Problem Possible cause and solution
Coffee dispensing is re-
peatedly interrupted
and the message Fill the
bean container appears in
the display.
This is not a fault.
The brew unit has not detected the ground coffee.
Certain types of coffee produce a small amount of
coffee when they are ground. Usually the grinder is
set too fine and the amount is set to minimum.
 Confirm the message withOK.
If the display appears with all types of coffee:
 Set the grinder to a coarser setting (see “Grinder
setting”).
 Select a larger amount of coffee.
Don't forget to check any drinks changed in “User
profiles”.
If the message only appears when dispensing certain
drinks:
 Check the amount of coffee set for this drink (see
“Amount of coffee”). Select a larger amount of
coffee.
 You may also need to set a coarser grinder setting.
The coffee machine
does not switch itself
on even though the On
at setting has been acti-
vated for the timer.
The system lock is activated.
 Deactivate the system lock.
The current day of the week has not been selected.
 Check the timer settings and change these if
necessary.
The coffee machine was not used after being
switched on automatically three times in succession
(vacation mode).
 Switch the machine on and dispense a drink.
The coffee machine does not switch on with the On
at timer while automatic descaling is being carried
out. This is not a fault. Select a different timer
setting.
Steam is dispensed in-
stead of water while
preparing hot water or
making tea.
It is likely that the wrong altitude has been set.
 Change the altitude settings (SettingsAltitude).
 If necessary, you can also change the temperature
settings for the drinks (Drinks parameters).
97