Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Guide to the machine
- Operation
- Miele@home
- Before using for the first time
- Bean system
- Filling the water container
- Switching on and off
- Spout adjustment
- Making drinks
- Expert mode
- Grinder setting
- Parameters
- Portion size
- Resetting drinks
- Profiles
- Profiles: creating and editing drinks
- MyMiele
- MobileStart
- Settings
- Cleaning and care
- Overview of cleaning intervals
- Cleaning by hand or in the dishwasher
- Unsuitable cleaning agents
- Cleaning the drip tray and waste container
- Cleaning the drip tray cover
- Cleaning the water container
- Cleaning the central spout
- Cleaning the cup rim sensor
- Cleaning the milk flask with lid
- Cleaning the milk valve (daily)
- Removing and cleaning the milk valve (once a month)
- Cleaning the bean containers
- Removing the brew unit and cleaning it by hand
- Cleaning the interior, inside of the machine door and drip tray
- Cleaning the front of the machine
- Maintenance programmes
- Rinsing the machine
- Rinsing the milk pipework
- Maintenance programme:
- Degreasing the brew unit and cleaning the interior
- Descaling the machine
- Automatic cleaning and descaling
- Problem solving guide
- After sales service and warranty
- Accessories
- Installation
- Technical data
- EU Conformity declaration
- UK Conformity declaration
- Copyrights and Licences
Problem solving guide
90
Problem Cause and remedy
F73 or
Check the brew unit
The brew unit cannot be positioned correctly or is
soiled. It is not possible to press the ground coffee.
Check whether you can remove the brew unit.
If you can remove the brew unit, rinse it under
running water.
Push the coffee ejector of the brew unit into the
correct position (see illustration).
Place the water container in the coffee machine
and close the machine door. Do not insert the
brew unit. Switch the coffee machine on.
This will initialise the brew unit motor and put it back
into the start position.
When Insert the brew unit appears in the display, put
the brew unit back in the coffee machine.
If you cannot remove the brew unit, switch the
coffee machine off. Wait for
approximately2minutes before switching the
machine back on again.
A manual maintenance
programme is prema-
turely aborted and the
following appears in the
display: Push the water
container in until it engages.
The water container has not been filled and inserted
correctly.
Check that you have selected the correct mark.
The symbols marked on the water container indicate
the amount of water required for the
Descale the appliance: and Clean the milk pipework:
maintenance programmes.
Fill the water container up to the relevant mark and
restart the process.