Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Guide to the machine
- Operation
- Miele@home
- Before using for the first time
- Bean system
- Filling the water container
- Switching on and off
- Spout adjustment
- Making drinks
- Expert mode
- Grinder setting
- Parameters
- Portion size
- Resetting drinks
- Profiles
- Profiles: creating and editing drinks
- MyMiele
- MobileStart
- Settings
- Cleaning and care
- Overview of cleaning intervals
- Cleaning by hand or in the dishwasher
- Unsuitable cleaning agents
- Cleaning the drip tray and waste container
- Cleaning the drip tray cover
- Cleaning the water container
- Cleaning the central spout
- Cleaning the cup rim sensor
- Cleaning the milk flask with lid
- Cleaning the milk valve (daily)
- Removing and cleaning the milk valve (once a month)
- Cleaning the bean containers
- Removing the brew unit and cleaning it by hand
- Cleaning the interior, inside of the machine door and drip tray
- Cleaning the front of the machine
- Maintenance programmes
- Rinsing the machine
- Rinsing the milk pipework
- Maintenance programme:
- Degreasing the brew unit and cleaning the interior
- Descaling the machine
- Automatic cleaning and descaling
- Problem solving guide
- After sales service and warranty
- Accessories
- Installation
- Technical data
- EU Conformity declaration
- UK Conformity declaration
- Copyrights and Licences
Cleaning and care
70
Connect together the angular
moulded hose and longer milk
pipework. Start by attaching the
moulded hose to the top of the
central spout. The black connecting
piece should be pointing to the rear.
Then, connect the bottom end of the
moulded hose to the dispensing unit.
Insert the milk pipework into the milk
valve on the left and right-hand sides.
Push the connecting pieces into the
silicone seal as far as they will go.
Check that the milk pipework is snug
against the housing and that the
cover can be easily attached.
Tip: If necessary, turn the milk
pipework towards the back at the
connecting piece on the right-hand
side.
Attach the milk valve cover as
follows: insert the pin in the top right-
hand corner and swivel the cover
backwards until a proper fit is
achieved.
Push the left-hand bean container
and maintenance container back into
the coffee machine. Attach the
central spout’s stainless steel cover.
Close the appliance door.