Operating instructions/Installation instructions

Installation
*INSTALLATION*
105
Building in the coffee machine
 Danger of injury due to incorrect
operation.
A machine that has not been built in
is not safe and can cause injuries.
Do not operate the coffee machine
unless it has been built in.
 Danger of damage due to
incorrect operation.
If the ambient temperature range is
not observed, the coffee machine
may not function properly.
The coffee machine may only be
operated within an ambient
temperature range of +16°C to
+38°C.
A minimum installation height of
850mm must be observed.
A door opening angle of 120° must
be ensured so that you can remove
the left-hand bean container.
Check that there is a gap of at least
299mm between the wall (or similar)
and the coffee machine so that you can
open the door wide enough to remove
the left-hand bean container (minimum
door opening angle of120°).
To install the machine, you will need a
TX20 screwdriver.
Tip: It is useful to have somewhere at
the height of the niche to place the
coffee machine on. This will make it
easier to connect the appliance to the
electricity supply.
Connecting the electricity supply
Observe the information under
“Electrical connection”.
 Connect the coffee machine to the
electricity supply.
Pushing in and aligning the coffee
machine
Take care not to trap or damage the
electrical connection when pushing
the appliance into the niche.
 Push the coffee machine all the way
into the niche until you feel a
resistance.
 Check the height of the coffee
machine to make sure that it is sitting
centrally in the niche and that it is
level. Align the appliance if
necessary.
Never align the coffee machine by
adjusting the door hinges. This will
prevent the milk flask from attaching
correctly and interfere with the milk
preparation process.
Now screw the coffee machine to the
furniture unit.