Operating instructions/Installation instructions

Installation
*INSTALLATION*
87
Building in the coffee machine
 Danger of injury due to incorrect
operation.
A machine that has not been built in
is not safe and can cause injuries.
Do not operate the coffee machine
unless it has been built in.
 Danger of damage due to
incorrect operation.
If the ambient temperature range is
not observed, the coffee machine
may not function properly.
The coffee machine may only be
operated within an ambient
temperature range of +16°C to
+38°C.
A minimum installation height of
850mm must be observed.
A door opening angle of 120° must
be ensured so that you can remove
the left-hand bean container.
Check that there is a gap of at least
299mm between the wall (or similar)
and the coffee machine so that you can
open the door wide enough to remove
the left-hand bean container (minimum
door opening angle of120°).
To install the machine, you will need a
TX20 screwdriver.
Tip: It is useful to have somewhere at
the height of the niche to place the
machine on. This will make it easier to
connect the machine to the electricity
and water supplies.
Connecting the water and electricity
supplies
Observe the information under
“Mains water connection” and
“Electrical connection”.
 Connect the coffee machine to the
water and electricity supplies.
Pushing in and aligning the coffee
machine
When pushing the machine into the
niche, make sure that the electrical
and mains water connections do not
get trapped or damaged.
 Push the coffee machine all the way
into the niche until you feel a
resistance.
 Check the height of the coffee
machine to make sure that it is sitting
centrally in the niche and that it is
level. Align the machine.
Never align the coffee machine by
adjusting the door hinges. This will
prevent the milk flask from attaching
correctly and interfere with the milk
preparation process.